Recording A Source; Using The Sleep Timer - Yamaha R-S500 Owner's Manual

Ampli-tuner
Hide thumbs Also See for R-S500:
Table of Contents

Advertisement

Available languages

Available languages

Recording a source

Notes
• Audio signals are not output to the TAPE REC or LINE 1 REC
output jacks when TAPE or LINE 1 is selected with the REC
OUT selector.
Audio signals are output to both the TAPE REC and the LINE 1
REC output jacks if when PHONO, DOCK, TUNER, CD,
SOURCE or LINE 2 is selected with the REC OUT selector.
• This unit must be turned on in order to record.
• The VOLUME, BASS, TREBLE, BALANCE and
LOUDNESS controls and the CD DIRECT AMP switch (R-
S700 only) and the PURE DIRECT switch have no effect on the
source being recorded.
• Check the copyright laws in your country before recording from
records, CDs, radio, etc. Recording copyright-protected
material may infringe on copyright laws.
REC OUT selector
1
Rotate the REC OUT selector on the front
panel to select the source you want to
record.
When SOURCE is selected, the current input source
is output.
2
Play the source and begin recording using
the recording device connected to the REC
jacks (TAPE and/or LINE 1) on the rear panel.
See page 12.

Using the sleep timer

Use this feature to automatically set this unit to standby
mode after a certain amount of time. The sleep timer is
useful when you are going to sleep while this unit is
playing or recording a source.
MAIN ZONE A
INPUT selector
Notes
• The sleep timer can only be set with the remote control.
• The sleep timer automatically turns off Zone 2. However,
Zone 2 components are not turned off.
1
y
• To disable the sleep timer, select "Sleep Off".
• The sleep timer setting can also be canceled by pressing
RECEIVER
the front panel) to set this unit to standby mode.
PLAYING AND RECORDING
Press SLEEP repeatedly to set the amount of
time before this unit is set to standby mode.
Each time you press SLEEP, the front panel display
changes as shown below.
The SLEEP indicator blinks while setting the amount
of time for the sleep timer.
If the sleep timer is set, the SLEEP indicator on the
front panel display lights up.
A
on the remote control (or MAIN ZONE
RECEIVER A
SLEEP
A
on
19
En

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

R-s700

Table of Contents