Uconnect 8.4 NAV Supplemental Owner's Manual page 233

232 UCONNECT SETTINGS
on the touchscreen, until a check-mark appears next to
setting, indicating that the setting had been selected.
• ParkView Backup Camera Delay
When the vehicle is shifted out of REVERSE (with camera
delay turned OFF), the rear camera mode is exited and
the navigation or audio screen appears again. When the
vehicle is shifted out of REVERSE (with camera delay
turned ON), the rear view image with dynamic grid lines
will be displayed for up to 10 seconds after shifting out of
"REVERSE" unless the forward vehicle speed exceeds
8 mph (12 km/h), the transmission is shifted into
"PARK" or the ignition is switched to the OFF position.
To set the ParkView Backup Camera Delay press the
"Controls" button on the touchscreen, the "settings"
button on the touchscreen, then the "Safety & Driving
Assistance" button on the touchscreen. Press the
"Parkview Backup Camera Delay" button on the touch-
screen to turn the ParkView Delay ON or OFF.
• Active ParkView Backup Camera Guidelines
Your vehicle may be equipped with the ParkView Rear
Back Up Camera Active Guidelines that allows you to see
active guidelines over the ParkView Back up camera
display whenever the shift lever is put into REVERSE.
The image will be displayed on the radio touchscreen
display along with a caution note to "check entire sur-
roundings" across the top of the screen. After five sec-
onds, this note will disappear. To make your selection,
press the "ParkView Backup Camera Active Guidelines"
button on the touchscreen, until a check-mark appears
next to setting, indicating that the setting had been
selected.
• Fixed ParkView Backup Camera Guidelines
Your vehicle may be equipped with the ParkView Rear
Back Up Camera Fixed Guidelines that allows you to see
fixed guidelines over the ParkView Back up camera
display whenever the shift lever is put into REVERSE.