Uconnect 8.4 NAV Supplemental Owner's Manual page 149

148 UCONNECT 8.4A/8.4AN
To Send A Text Message:
1. Push the Uconnect Phone button.
2. Wait for the beep.
3. Say "Text."
4. Uconnect will prompt you "Say the phone number, or
full name and phone type of the contact you want to
send a message to."
5. Wait for the beep and say a contact that is in your
phonebook, or a mobile phone number that you
would like to send the message to.
6. Uconnect will prompt you "Please say the message
that you would like to send" (If you do not hear this
prompt, you may not have an active subscription with
Uconnect Access).
7. Wait for the beep, and then dictate any message up to
140 characters. If you exceed 140 characters, you will
hear the following prompt: "Message was too long;
your message will be truncated."
8. Uconnect will then repeat the message back to you.
9. Uconnect will prompt you: To add to your message,
say "Continue"; to delete the current message and
start over, say "Start Over"; to send the current
message, say "Send"; to hear the message again, say
"Repeat."
10. If you are happy with your message and would like
to send it, wait for the beep and say "Send."
11. Uconnect will then say "Sending your message."