Assembling The Unit - Stihl FR 460 TC-M Instruction Manual

English

Assembling the Unit

Mounting the Support Frame
1
2
Remove shipping lock (adhesive
N
tape).
Take the M10x20 screw (1) with
N
washer (2) out of the support frame.
4
3
Mount the support frame (3) to the
N
powerhead (4) with screw (1) and
washer (2) – tighten down hex.
head screw with 17 mm wrench to
torque of 20 Nm (177 lbf.in).
14
Mounting the Drive Tube
2
Push the lug (1) on the drive tube
N
into the slot (2) in the coupling
sleeve as far as stop.
When correctly installed, the red line (3)
1
(arrow point) must be flush with the end
of the coupling sleeve.
2
Tighten down the star knob (4)
N
firmly.
1
3
4
Mounting Loop Handle with Barrier Bar
2
1
Fit the square nuts (1), raised sides
N
facing up, in the barrier bar (2); line
up the holes.
4
3
5
6
7
7
Place the clamp (3) in the loop
N
handle (4) and position them both
against the shaft (5).
Position the clamp (6) against the
N
shaft.
Place the barrier bar (2) in position
N
as shown.
Line up the holes.
N
FR 460 TC-M
1
2