Approved Kombiengines; Mounting The Kombitool; Assembling The Unit - Stihl FH-KM Instruction Manual

English
4.3 Working Technique
Working position and method are the same as
for a brushcutter: Sweep the cutter bar to and fro
in an arc just above the ground.
5

Approved KombiEngines

5.1 KombiEngines
Only use KombiEngines supplied or explicitly
approved by STIHL for use with the attachment.
This KombiTool may be operated only in combi‐
nation with the following KombiEngines:
1)
KM 56 R, KM 85 R , KM 94 R, KM 111 R,
KM 131, KM 131 R, KMA 130 R, KMA 135 R,
KMA 80.0 R, KMA 120.0 R
5.2 Brushcutters with split shaft
The KombiTool can also be mounted on STIHL
brushcutters with a split shaft (T-models) (basic
power tools).
This KombiTool can therefore also be used on
the following machine:
STIHL FR 131 T
1)
Only outside EU
6
WARNING
Refer to the power tool's User Manual for how to
use the barrier bar.
6

Mounting the KombiTool

2
► Push the lug (1) on the drive tube into the
slot (2) in the coupling sleeve as far as stop.
When correctly installed, the red line (3) (arrow
point) must be flush with the end of the coupling
sleeve.
► Tighten down the star knob (4) firmly.
6.1 Removing the KombiTool
► Reverse the above sequence to remove the
drive tube.
7

Assembling the Unit

7.1 Removing the Potective Cap
If a cap is fitted on the end of the KombiTool's or
basic power tool's drive tube:
5 Approved KombiEngines
1
3
4
0458-476-0121-D