Assembling The Unit - Stihl FR 480 C Instruction Manual

2
1
4
Operate the 12V/24V charging cable
only in dry locations at an ambient
temperature between 0°C and +40°C.
N Move the slide control to STOP-0
(h).
N Insert the barrel connector (1) into
the charge socket (2) on the power
tool.
N Insert the power supply adapter (3)
into a vehicle's socket – the
vehicle's voltage and the operating
voltage of the 12V/24C charging
cable must be the same.
Note: If the 12V/24V charging cable is
connected to a DIN 4165 vehicle socket,
rotate and remove the red cap.
N Check that all connections are firm
and make good contact – poor
contact may cause a fire.
The charge process begins and the
green LED (4) comes on.
FR 480 C
Charge time
10 minutes:
1 hour:
The charge time is dependent on a
number of factors, including battery
condition, ambient temperature, etc.,
and may therefore vary from the
specified charge times.
N After charging, disconnect the
power supply adapter from the
vehicle's socket.
N Disconnect the barrel connector
from the power tool's charge socket.
3
Power tool may be
started
Battery is fully charged

Assembling the Unit

Mounting the Support Frame
4
3
2
1
N Loosen and remove the M10x35
screw (1) with lock washer (2) and
plain washer (3) from the
powerhead.
N Secure the support frame (5) to the
powerhead with the screw and
washer (torque down to 20 Nm).
English
5
15