Stihl FR 460 TC-M Instruction Manual page 17

Insert the screws (7) in the holes
N
and screw them into the barrier bar
as far as stop.
Keep other parts in a safe place.
N
Go to "Securing the Loop Handle".
N
Mounting Loop Handle without Barrier
Bar (not approved in all markets)
6
6
5
5
2
1
3
4
7
7
Place the clamp (1) in the loop
N
handle (2) and position them both
against the shaft (3).
Position the clamp (4) against the
N
shaft.
Line up the holes.
N
Fit washers (5) on the screws (6)
N
and insert the screws in the holes.
Fit the square nuts (7) and screw
them down as far as stop.
FR 460 TC-M
Keep other parts in a safe place.
N
Go to "Securing the Loop Handle".
N
Securing the Loop Handle
A
2
1
Mount the loop handle (1) about 20
N
cm (8 in) (A) forward of the control
handle (2).
Line up the loop handle.
N
Tighten down the screws firmly –
N
lock the nuts if necessary.
Checking Position of Throttle Cable
The whole length of the throttle cable
must run parallel to the flexible shaft.
If this is not the case:
A
2
B
1
Push the throttle cable (1) into the
N
cable retainer (2) about 20 cm (8 in)
in front of the powerhead (distance
A).
Push the throttle cable (1) into the
N
cable retainer (3) about 15 cm (6 in)
from the end of the shaft (distance
B).
Go to "Adjusting the Throttle Cable".
English
1
3
15