Stihl FR 460 TC-M Instruction Manual page 27

WARNING
The throttle cable must be positioned
parallel to the flexible shaft, not wrapped
around it.
Keep the flexible shaft as straight as
N
possible.
Rest the deflector on the ground.
N
WARNING
Check that the cutting attachment is not
touching the ground of any other
obstacles.
FR 460 TC-M
Make sure you have a safe and
N
secure footing.
Hold the unit steady with your left
N
hand on the shroud and put one foot
on the support frame and press
down.
Hold the starter grip with your right
N
hand.
Pull the starter grip slowly until you
N
feel it engage and then give it a brisk
strong pull.
NOTICE
Do not pull out the starter rope all the
way – it might otherwise break.
Do not let the starter grip snap back.
N
Guide it slowly back into the housing
so that the starter rope can rewind
properly.
Continue cranking.
N
If the engine does not start: Turn the
N
choke knob to the start position }
and repeat starting procedure.
Machine is ready for use.
If you have started the machine for the
first time, refer to the notes on "Starting
for first time" in section "Other Hints on
Starting".
If the engine was started in the start
N
position }: Briefly press down the
trigger lockout and the pull the
throttle trigger at the same time –
the choke knob moves to the run
position (F) and the engine settles
down to idling speed.
Your machine is now ready for
operation.
WARNING
The cutting attachment must not rotate
in the run position F with the engine at
idling speed.
If the cutting attachment rotates when
the engine is idling, refer to notes in
chapter on "Adjusting the Throttle
English
25