Spark Plug - Stihl FR 460 TC-M Instruction Manual

English
4
The cover plate kits contain the following
parts for converting the power tool:
4 Synthetic fabric filter element for the
air filter
Instruction sheet describing the
–
conversion.
After installing the cover plate kit:
Set the shutter (2) to the winter
N
position.
At temperatures above -10°C
Remove the parts of the cover plate
N
kit and refit the standard parts for
summer operation.
Depending on the ambient temperature:
Set the shutter (2) to the summer or
N
winter position.
Clean the air filter.
Loosen filter cover mounting
N
screws.
Remove the filter cover.
N
32
Clean away loose dirt from around
N
the filter (5) and inside the filter
2
cover.
Knock the filter (5) out on the palm
N
of your hand or blow it clear with
compressed air from the inside
outwards.
In case of stubborn dirt or sticky filter
fabric:
Wash the filter in a clean, non-
N
flammable solution (e.g. warm
soapy water) and then dry.
Always replace a damaged filter.

Spark Plug

If the engine is down on power,
N
difficult to start or runs poorly at idle
speed, first check the spark plug.
Fit a new spark plug after about 100
N
operating hours – or sooner if the
electrodes are badly eroded. Install
only suppressed spark plugs of the
type approved by STIHL – see
"Specifications".
Removing the Spark Plug
1
Rotate the screw (1) in the cap (2)
N
until the screw head projects from it.
3
Lift the front of the cap (2) and push
N
it to the rear to disengage.
Leave the cap to one side.
N
Pull off the spark plug boot (3).
N
Unscrew the spark plug.
N
FR 460 TC-M