Stihl FR 460 TC-M Instruction Manual page 21

WARNING
Wear protective gloves to reduce the
risk of direct contact with the sharp
cutting edges.
Mount only one metal cutting
attachment.
Check direction of rotation of cutting
attachment
1 2
4
3
5 6
Cutting attachments 1, 2, 3 and 4 may
be mounted either way round – they
must be turned over regularly to help
avoid one-sided wear.
The cutting edges of the grass cutting
blades 5 and 6 must point clockwise.
WARNING
Direction of rotation is indicated by an
arrow on the inside of the deflector.
FR 460 TC-M
Place the cutting attachment (6) on
N
the thrust plate (7).
WARNING
Collar (see arrow) must engage the
cutting attachment's mounting hole.
Securing the cutting attachment
Fit the thrust washer (8) – convex
N
side must face up.
Fit the rider plate (9).
N
Block the shaft (10).
N
Use the combination wrench (12) to
N
screw the mounting nut (11) on to
the output shaft counterclockwise
and tighten it down firmly.
WARNING
If the mounting nut has become too
loose, fit a new one.
NOTICE
Remove the tool used to block the shaft.
Removing the Metal Cutting Attachment
WARNING
Wear protective gloves to reduce the
risk of direct contact with the sharp
cutting edges.
Block the shaft.
N
Unscrew the mounting nut
N
clockwise.
Remove cutting attachment and its
N
mounting hardware from the
gearbox – but do not remove the
thrust plate (7).
English
19