Safety Instructions - Thermoplan Black & White BW3-CTMC Operating Instructions Manual

2 Important notes, safety

2.3 Safety instructions

General safety instructions
- In an emergency, switch off the machine using the main switch. Remove the plug or remove the fuse of the
domestic electrical installation. Contact the Service partner.
- The machine is for indoor use only.
- The coffee, milk and water spout can get very hot. Avoid direct contact (risk of burning and scalding)!
- Clean the machine before taking it out of service for a longer period of time (day off, company holiday, etc.).
Then unplug it from the mains and remove the remaining coffee beans from the bean hopper. Remove, empty
and clean the milk container. Turn off the water tap underneath the drip tray and close the cutoff valve.
- Do not use the machine if it does not work properly or if there are signs of damage. In the event of a malfunction
or if the machine has been damaged, contact your service partner.
- The machine may only be used in a hygienic and ergonomic environment. The user must have enough space
and the working area must be well lit.
- If a tube, cable or plug is damaged, do not use the machine, as it will be dangerous. Have the faulty part
repaired or replaced by trained service staff.
- While the grounds drawer is removed, you must not reach up inside the inner casing.
- Inserting objects of any kind into the machine or opening the casing is strictly prohibited.
- Make sure children and any other persons are kept away from the machine whilst it is being repaired. If distracted,
accidents may happen.
- This dispensing machine is not intended to be used by persons (including children) with reduced physical,
sensory or mental capabilities or with a lack of experience and knowledge unless they were explicitly trained
by a responsible person or briefed in the use of the dispensing machine to ensure their safety. Children must
be kept away from the machine at all times.
Positioning the machine
- The machine must only be set up and installed by trained service staff.
- The machine must not be installed in a warm nor in a damp environment. The ambient temperature must be
between 16 °C (60.8°F) and 32 °C (89.6°F).
- Do not install the machine in an area where a water jet could be used to clean the machine.
- Never place the machine on a hot surface. Do not use the machine near open flames.
- Do not position cables near or on hot parts of the machine. Protect the cables from heat sources and any sharp
edges.
- Position the machine on a flat, horizontal, stable and heat-resistant surface.
- Install the machine and any cables out of reach of children.
- The coffee machine must be free-standing so as not to affect the air circulation. Therefore leave a gap of
at least 50mm next to the vent slots.
-
The top of the machine must be at least 1.5 m from the floor
- Temporary storage: Store in a dust-free and dry area, the temperature must never fall below 0°C!
© 2011 by Thermoplan, subject to change
Operating instructions BW3-CTMC + BW3-RF
6