Maintenance - PowerTec BD1500 Owner's Manual

8
WARNING
For your own safety, turn the switch OFF and remove
the plug from the electrical outlet before adjusting or
performing maintenance or lubrication work on the
belt/disc sander.
GENERAL MAINTENANCE
8
Before using, check to make sure parts are not damaged,
missing, or worn; check for alignment of moving parts,
binding of moving parts, improper mounting, or any other
conditions that may affect the sander operation. Should
any of these conditions exist, do not use the
belt/disc sander until properly repaired or parts are
replaced. Frequently blow or vacuum dust from all sanding
parts and motor housing.

MAINTENANCE

WARNING
Any attempt to repair or replace electrical parts on this tool
may be hazardous. Repairs should be done by a qualified
service technician.
LUBRICATION
Ball bearings are grease packed at the factory and require
no further lubrication. Use a spray lubricant on all moving
table parts to ensure smooth operation.
8