Extension Cords; Motor; Electrical Connections - PowerTec BD1500 Owner's Manual

• Do not modify plug provided. If it will not fit in outlet,
have proper outlet installed by a qualified electrician.
Use only 3-wire extension cords, that have 3-prong
grounding type plugs and matching 3-conductor
receptacles that accept the machine's plug, as shown in
Figure 12.
Figure 12
Properly Grounded Outlet
Ground Outlet Box
Grounding Prong
6 Grounding Prong
3-Prong Plug
3-Prong Plug
WARNING
Do not permit fingers to touch the terminals of plug when
installing or removing from outlet.
• Inspect tool cords periodically, and if damaged, have
repaired by an authorized service facility.
• The conductor with insulation having an outer surface
that is green with or without yellow stripes is the
equipment-grounding conductor. If repair or replacement
of the electric cord or plug is necessary, do not connect
the green (or green and yellow) wire to a live terminal.
A temporary 3-prong to 2-prong grounding adapter (see
Figure13) may be used to connect this plug to a matching
2-conductor receptacle as shown in figure 13. The
temporary adapter should be used only until a properly
grounded outlet can be installed by a qualified electrician.
Figure 13
Grounded outlet Box
Adapter
In Canada, the use of temporary adapter is not permitted
by the Canadian Electric Code. Where permitted, the rigid
green tab or terminal on the side of the adapter must be
securely connected to a permanent electrical ground such
as a properly grounded water pipe, a properly grounded
outlet box or a properly grounded wire system.
• Many cover plate screws, water pipes and outlet
boxes are not properly grounded. To ensure proper
ground, grounding means must be tested by a qualified
electrician.

EXTENSION CORDS

Use proper extension cords. Make sure the extension
cord is in good condition. Use only 3-wire extension cords
have 3-prong grounding type plugs and 3-pole receptacles
which accept the tool plug. When using an extension cord,
make sure to use one heavy enough to carry the current
of the machine. An undersized cord will cause a drop in
the voltage, resulting in loss of power and overheating.
Use the table to determine the minimum wire size
(A.W.G.) extension cord.
Extension Cord Length
Wire Size................. A.W.G.
Up to 25 ft............... 16 gauge
NOTE: Using extension cords over 25 ft. long is not
recommended.

MOTOR

The sander is equipeed with a 2.5 Amps motor. The 120
Volt motor has the following specifications::
Horsepower .................................................................. 1/3
Voltage .........................................................................120
Amp ...............................................................................2.5
Hertz ...............................................................................60
Phase .......................................................................Single
RPM ............................................................................3450

ELECTRICAL CONNECTIONS

• Turn the switch off and disconnect the machine
• Some electrical wiring and connection work must be
• Scheme of the motor and electric wiring inside this
• There is a green grounding wire fastened to the frame
• The Motor is rated for use at 120 Volts.
• Connect this machine to 3-Conductor Power outlet with
Grounding
• Use only 3-pronged Extension Power Cord with
Means
• When changing the power cord, use only 3-pronged
• The Power switch is a Single Pole Rocker switch with
Figure 14
from power source before performing any repair or
maintenance work.
performed by a qualified electrician in accordance with
local regulations.
machine is shown in Figure 14.
of the machine to provide Shock Protection. Do not
disconnect the Grounding Wire from the frame.
appropriate rating only.
appropriate rating with this machine.
Power Cord with appropriate rating.
Locking Mechanism. Remove the Key when not in use
to prevent accidents.