System Board; Removing The System Board - Dell SD630-S Owner's Manual

CAUTION: The display module connector is a ZIF (zero insertion force) connector. Ensure
that the locking tab on the connector is released before removal and insertion. The locking
tab must be engaged after insertion.
5. Connect the display module cables to the control panel board.
Figure 64. Installing the VGA module
1. screw
3. VGA module
Next steps
Follow the procedure listed in the After working inside your system section.
Related Links
Safety instructions
After working inside your system

System board

Removing the system board

Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that are shipped with your product.
132
2. VGA module cable
4. control panel