Table of Contents
Advertisement
Figure 21. Installing the memory module
1.
memory module
3.
memory module socket ejector (2)
Next steps
1.
Install the cooling shroud.
2.
Follow the procedure listed in the After working inside your system section.
3.
Press F2 to enter System Setup, and check the System Memory setting.
The system should have already changed the value to reflect the installed memory.
4.
If the value is incorrect, one or more of the memory modules may not be installed properly. Ensure
that the memory module is firmly seated in the memory module socket.
5.
Run the system memory test in system diagnostics.
Related Links
Safety instructions
Before working inside your system
After working inside your system
Hard drives
All hard drives connect to the system board through the hard drive backplane. Hard drives are supplied in
hot swappable hard drive carriers that fit in the hard drive slots.
CAUTION: Before attempting to remove or install a hard drive while the system is running, see the
documentation for the storage controller card to ensure that the host adapter is configured
correctly to support hot swappable hard drive removal and insertion.
CAUTION: Do not turn off or reboot your system while the hard drive is being formatted. Doing
so can cause a hard drive failure.
82
2.
alignment key
Advertisement
Table of Contents
Troubleshooting
