Table of Contents
Advertisement
Figure 14. Installing the Quick Sync bezel
1.
bezel lock
Related Links
Safety instructions
Removing the system cover
Prerequisites
1.
Follow the safety guidelines listed in the Safety instructions section.
2.
Turn off the system, including any attached peripherals.
3.
Disconnect the system from the electrical outlet and disconnect the peripherals.
4.
If installed, remove the optional bezel. For more information, see the Removing the optional front
bezel section.
Steps
1.
Rotate the latch release lock counter clockwise to the unlocked position.
2.
Lift the latch toward the back of the system.
The system cover slides back and the tabs on the system cover disengage from the slots on the
chassis.
NOTE: The position of the latch may vary depending on the configuration of your system.
3.
Hold the cover on both sides, and lift the cover away from the system.
68
2.
Quick Sync bezel
Advertisement
Table of Contents
Troubleshooting
