Removing Memory Modules; Removing The System Board Tray - Dell PowerVault 775N Installation And Troubleshooting Manual

Removing Memory Modules

CAUTION: Before you perform this procedure, you must turn off the system and disconnect it from its
power source. For more information, see
Your System."
CAUTION: See "Protecting Against Electrostatic Discharge" in the safety instructions in your System
Information document.
1. Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet.
2. Remove the cover (see
3. Locate the memory module connectors from which you will remove memory modules (see
4. Press down and outward on the memory module connector ejectors until the memory module pops out of the connector
(see Figure 6-5).
5. Repeat steps 3 and 4 of this procedure to remove any other memory modules.
6. Perform steps 4 through 8 of the procedure in
System Board Tray
See Figure A-3 to identify the system board components.

Removing the System Board Tray

CAUTION: Before you perform this procedure, you must turn off the system and disconnect it from its
power source. For more information, see
Your System."
CAUTION: See "Protecting Against Electrostatic Discharge" in the safety instructions in your System
Information document.
1. Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet.
2. Remove the cover (see
3. Rotate the system board tray levers up simultaneously until the tray releases from the chassis (see
Figure 6-6. Removing and Installing the System Board Tray
"Safety First—For You and Your System
"Removing the Cover" in "Troubleshooting Your System").
"Performing a Memory
"Safety First—For You and Your System
"Removing the Cover" in "Troubleshooting Your System").
" in "Troubleshooting
Figure
Upgrade."
" in "Troubleshooting
A-3).
Figure 6-6).