Computherm Q7 Operating Instructions Manual page 20

using a stove, more gas is needed to keep a pan of water boiling
than to just keep it warm.)
–
• The switches are deactivated by factory default
PROG PROG
(their start time is ), but they can be activated at need. Their
start time can be freely set between and at 10-minute
intervals given the constraint, that their start time should be in
increasing order and a difference of at least 10 minutes should
be between them. This minimum 10-minute difference is going
to be preserved even if a previously activated switch is modified,
in order to avoid co-occurring or overlapping switches. In such
a case, the device automatically increases the start time of the
affected switches until a difference of at least 10 minutes between
them is reached. If the start time of a switch would be later than
because of this automatic modification, then that switch is
deactivated instead.
20