Switching Between The Heating And Cooling Mode - Computherm Q7 Operating Instructions Manual

buttons on the front panel of the device, set the minute value
of the current time.
When you wish to continue modifying the settings, please press the
"DAY" button again. If you wish to finish settings, confirm them by
pressing the "SET" button. At this point adjusted data are recorded
and the device goes back to the main screen (if no buttons are pressed
for at least 15 seconds, the settings are automatically confirmed and the
device goes back to the main screen).

3.3 Switching between the heating and cooling mode

There is a possibility to easily switch between the heating and cooling
mode of the thermostat. The output terminals No. 1 (NO) and No. 2
(COM) of the thermostat are closed below the set temperature in heat-
ing mode, and they are closed above the set temperature in cooling
mode (taking the switching sensitivity into account). The closed state
12