Working With The Ops300; Operating Modes; Reseting Default Values; Ops300 Color Codes - Analog way ops300 User Manual

4-3. WORKING WITH THE OPS300

Operating modes

The OPS300 offers 2 modes to work from: the
Mode, which turns your
* NOTE * : the OPS300 will only let you work on your preview screen (direct access to main screen is locked).
In Matrix mode, the OPS300
To choose which mode the
by rotating the scroll knob. Then press the
mode by rotating the scroll knob, and press the
MENU] button to return to the main menu.

Reseting default values

It is strongly recommended resetting all of the default values of your
shows and events. To do so, press the
corresponding knob. Then press the
by rotating the scroll knob, and press the
factory settings. This operation should take approximately 30 seconds.

OPS300 color codes

Analog Way engineers have developed a handy, user friendly way of identifying machine status on the front
panel, via the use of color codes on the buttons of the machine. All new
codes, for quick recognition of the status of any device of the range, at any given time.
For the OPS300, button color codes are as follow:
- Sources on the Main output are indicated in
- Sources on the Preview output are indicated in
- Buttons in the layer section turn
respectively the Main or Preview window,
- Menu buttons are indicated in green,
- Selecting a button with an available source or function will cause that button to blink
preview, or red once it is on the Main output,
- TAKE button reacts as follows:
• If take function is available, the button will appear in green.
• When the take function is active, it will light up red.
#1 = Source, Layer or Window is on Main
Solid red:
#2 = Freeze enable
#1 = Source or Layer is on Preview
Solid green:
#2 = Function available for modification
#3 = Current output on Matrix Mode
Dim green:
Button available for selection
Mixer
OPS300 into a true 12 x 2 scaled matrix with numerous effects.
loses the use of layers, PIPs and logos.
OPS300 will work in, press the
[ENTER]
[EXIT/MENU]
[ENTER] button to enter the Control sub-menu. Select Default Values
[ENTER]
red or green, depending on whether the selected layer is active in
Mode, which is the OPS300
[EXIT/MENU] button and select Mode in the menu
button to enter the Mode sub-menu. Select the desired
[ENTER] button to confirm your choice. Press the
OPS300
button and select Control in the menu by rotating the
button to enter your choice to restart your
Analog Way
red when active,
green when active,
Blinking red:
Blinking green:
Dim red:
default mode and the
unit before setting up your
OPS300
machines use the same
green
Active Layer or Source for modification on Main
Active Layer or Source for modification on Preview
Stand-by button
Matrix
[EXIT/
with its
on the
29