Usb Port; Esata Port; Remove S-Ata Devices; The Esata / Usb Port - Medion The Touch X9613 User Manual

USB Port

Note
Devices connected directly to the USB bus should not draw more than 500
mA. The voltage output is protected by a fuse (Limited Power Source ac-
cording to EN 60950). Should the devices need more power than this, it will
be necessary to provide a hub (distributor / booster).
On the USB it is possible to connect up to 127 devices which correspond to the USB stan-
dard (1.1 and 2.0 supported).
The data transfer speed is 1.5 Mbit/s or 12 Mbit/s, depending on the device connected.
USB 2.0 can reach up to 480 Mbit/s.
Note
If possible, always connect your USB devices to the same port where it has
been installed. Otherwise you will get a new ID and your operating system
will ask for a new installation of the driver.

eSATA port

eSATA stands for "external Serial ATA" and is used for connecting external hard disks.
Unlike common USB standards, the transmission speed of an eSATA connection is higher
than that of external USB hard disks.

Remove S-ATA devices

Before removing an S-ATA hard disk from your All-In-One PC, click on the icon "Safely
remove hardware" in the task bar and then on the hard disk to be removed.
USB Port
- 45 -