Table of Contents
Advertisement
USB port
Diagram reference: L
Note
Devices connected directly to the USB bus should not
draw more than 500 mA.
The voltage output is protected by a fuse (Limited
Power Source according to EN 60950).
Should the devices need more power than this, it will
be necessary to provide a hub (distributor / booster).
On the USB it is possible to connect up to 127 devices which
correspond to the USB standard (1.1 and 2.0 supported).
The data transfer speed is 1.5 Mbit or 12 Mbit, depending on the
device connected. USB 2.0 can reach up to 480 Mbit.
Note
If possible, connect your USB devices always to the
same port were it has been installed. Otherwise you
will get a new ID and your operating system asks for a
new installation of the driver.
Operation
53
Advertisement
Table of Contents
Troubleshooting
