Table of Contents
Advertisement
USB Port
Diagram reference: E
Note
Devices connected directly to the USB bus should not draw more than 500
mA. The voltage output is protected by a fuse (Limited Power Source ac-
cording to EN 60950). Should the devices need more power than this, it will
be necessary to provide a hub (distributor / booster).
On the USB it is possible to connect up to 127 devices which correspond to the USB stan-
dard (1.1 and 2.0 supported).
The data transfer speed is 1.5 Mbit/s or 12 Mbit/s, depending on the device connected.
USB 2.0 can reach up to 480 Mbit/s.
Note
If possible, always connect your USB devices to the same port where it has
been installed. Otherwise you will get a new ID and your operating system
will ask for a new installation of the driver.
UK/ N. IRELAND HELPLINE 0871 3761020
REP. IRELAND HELPLINE 1-800-992508
(calls are charged at 7p per min from a standard landline, calls from mobiles could be higher)
- 46 -
Advertisement
Table of Contents
Troubleshooting
