Table of Contents
Advertisement
USB Port
Diagram reference: C
Note
Devices connected directly to the USB bus should not draw more than
500 mA. The voltage output is protected by a fuse (Limited Power
Source according to EN 60950). Should the devices need more power
than this, it will be necessary to provide a hub (distributor / booster).
On the USB it is possible to connect up to 127 devices which correspond to the USB
standard (1.1 and 2.0 supported).
The data transfer speed is 1.5 Mbit/s or 12 Mbit/s, depending on the device connected.
USB 2.0 can reach up to 480 Mbit/s.
Note
If possible, always connect your USB devices to the same port where it
has been installed. Otherwise you will get a new ID and your operating
system will ask for a new installation of the driver.
USB Port
33
Advertisement
Table of Contents
Troubleshooting
