Table of Contents
Advertisement
subwoofers exhibiting distorted audio, poor frequency response, low output, etc. Certain settings in the subwoofer can only
be accessed via the EAW Mosaic application for iOS. Sometimes these settings can be the cause of what appears to be poor
performance when the subwoofer is isolated on the test bench or when compared to other units in inventory. All settings are
reset to factory default when the Restore procedure is performed.
5.
Rotate the DSP Navigation / Edit Wheel to select Restore.
6.
Press the DSP Navigation / Edit Wheel and the "Restore factory defaults?" prompt
appears.
7.
Select "No" to return to the Settings sub-menu without changing any of the
subwoofer settings.
8.
Select "Yes" to restore factory default settings and return to the Main Menu.
About:
The About screen provides the user with information about the subwoofer's current input
source, model number, firmware and network address details. Should you ever need to
contact the EAW Application Support Group or EAW Service Department for assistance with
your subwoofer, you may be asked to provide some of the information presented here.
Radius RSX18 Home Screen
After 5 seconds have passed with no turn or press of the DSP Navigation / Edit Wheel the Home
Screen is displayed, showing primary settings, levels and statuses at a glance.
Two indicators and the loudspeaker model are shown at the top of the LCD display.
This row of information is available on the Home Screen and Menu screens any time the
display is illuminated.
•
Left - Status "LED" indicator
o
Green indicates that the loudspeaker is online and functioning normally.
o
Red indicates that the amplifier is clipping or that a fault has been detected
in the loudspeaker system.
•
Right – Ethernet Link "LED" indicator
o
Amber indicates that an Ethernet link has been established between the loudspeaker and a network
switch or other Radius loudspeaker.
Input is indicated as Analog unless a Dante source is assigned to the loudspeaker.
Crossover indicates the currently selected crossover configuration.
Level shows any gain adjustment from nominal that has been applied by the user.
Input level is indicated via meter on the right of the display, with clip indicator above it. The meter range is -60 to 0 dBFS with a color
gradient from green to red. The clip indicator is displayed when the input signal exceeds 0dBFS.
36
Advertisement
Table of Contents
