Table of Contents
Advertisement
Rear Panel Home Screen and Menu Navigation
The RADIUS Series Loudspeaker's LCD Display and DSP Navigation / Edit Wheel are used to monitor the loudspeaker's status and
adjust its DSP settings. Rotate the DSP Navigation / Edit Wheel to change the highlighted sub-menu or to change parameter values.
Press it to select a sub-menu or to enter values.
Radius RSX208L Menus
Upon power on and initialization of the loudspeaker the Main Menu is displayed. Here the user can
adjust the RSX208L's output level, alignment delay settings, voicing profile and user preferences,
initiate a test of the loudspeaker's output and run the Automatic Array Optimization sequence.
If the Home Screen (see below) is displayed, pressing or turning the DSP Navigation / Edit Wheel
reveals the Main Menu.
Level
Selecting Level allows the user to adjust the loudspeaker's output level in 0.5 dB increments ranging
from -10 dB to +10 dB. Rotating the DSP Navigation / Edit Wheel changes the level value and pressing it returns to the Main Menu.
After 5 seconds have passed with no change to the Level parameter the Home Screen is displayed.
OptiLogic
The RSX208L features Automatic Array Detection & Optimization that makes it easier and faster to sound better. The user enters a
few parameters - minimum and maximum audience distances and array height - then initiates the optimization sequence.
Using integrated infrared transceivers and tilt sensors, the position and splay angle of each RSX208L module within the array is
automatically detected. The modules are grouped accordingly and the system's acoustical output is optimized to compensate for
array size, audience geometry and throw distance. Array Optimization can be used with or without a network or software application.
From any RSX208L within the array, select the OptiLogic sub-menu to show the current status of the
RSX208L within the array. If the array has not already been optimized, or if the array has changed
since it was last optimized, the display will indicate "Not optimized". The position of the speaker
within the array is indicated. The speaker's splay angle relative to the speaker above it (Angle) is also
show. Select Next to proceed with the entry of parameters needed for the optimization sequence or
select Back to return to the Main Menu.
1.
Enter the Array Height, measured as the distance between the ground and the Top of the
upper-most RSX208L in the array.
Rotate the DSP Navigation / Edit Wheel to highlight Top then press it.
Rotate the DSP Navigation / Edit Wheel to specify the height then press it to enter the value.
The array height parameter ranges from minimum 0 m/feet to maximum 99.0 m / 324 feet
Select Next to proceed with the optimization sequence.
Select Back to return to the OptiLogic sub-menu.
2.
Enter the Audience parameters, measured as the distance from the point on the ground directly beneath front of the array
to the Front and to the Rear of the desired coverage area.
Rotate the DSP Navigation / Edit Wheel to highlight Front then press it.
Rotate the DSP Navigation / Edit Wheel to specify the distance then press it to enter the value.
Rotate the DSP Navigation / Edit Wheel to highlight Rear then press it.
Rotate the DSP Navigation / Edit Wheel to specify the distance then press it to enter the value.
Front and Rear parameters range from minimum 0 m/feet to maximum 999.0 m / 3276 feet.
Select Back to return to the Array Height sub-menu.
3.
Select Optimize to finalize parameter entry and initiate the optimization sequence. The display will indicate "Optimizing
Array..." When optimization is complete, the OptiLogic sub-menu will be shown and status will indicate "Optimized".
4.
Select Back to return to the Main Menu or Next to repeat the optimization sequence using different audience and array
height parameters.
20
Advertisement
Table of Contents
