Table of Contents
Advertisement
Sub:
Pink noise can be activated for manual testing of the subwoofer's transducer and amplifier.
1.
Rotate the DSP Navigation / Edit Wheel to select Sub.
2.
Press then turn the DSP Navigation / Edit Wheel to change the status to "On" and activate pink noise.
3.
Press then turn the DSP Navigation / Edit Wheel to change the status to "Off" and deactivate pink noise.
Note: Pink noise will continue to be emitted until the Sub's status is manually changed to "Off" by the user or as a
result of running the Auto Output Check sequence.
Select Back to exit Output Check and return to the Main Menu.
Settings
From the Settings menu, the user can configure LCD display preferences, restore the subwoofer to
factory default settings and view network address and firmware version information.
Screen:
To accommodate aesthetically sensitive situations where the bright LCD display may be
distracting, the RSX12 provides three options for the user to optimize the LCD display
behavior and brightness. To change settings, rotate the DSP Navigation / Edit Wheel to
select Screen
Bright
This is the default setting suitable for well illuminated indoor/outdoor venues or
when operating in bright sunlight.
Menu navigation and parameter entry is performed with the LCD display at maximum brightness.
The Home Screen is also displayed at maximum brightness.
Dim
When maximum brightness settings become too distracting such as in darker theaters or evening outdoor events,
the LDC display can be dimmed.
Menu navigation and parameter entry is performed with the LCD display at reduced brightness.
The Home Screen is also displayed at reduced brightness.
Off
For the most aesthetically sensitive applications, the home screen can be turned off.
Menu navigation and parameter entry is performed with the LCD display at maximum brightness.
The Home Screen is blank in this mode.
Units:
Select meters or feet as the preferred unit of measurement.
Restore:
Factory settings can quickly and easily be restored. This is convenient for users managing rental inventories or for resetting a
mobile production system prior to deployment to the next venue or job site. It is also a good first step when troubleshooting
subwoofers exhibiting distorted audio, poor frequency response, low output, etc. Certain settings in the subwoofer can only
be accessed via the EAW Mosaic application for iOS. Sometimes these settings can be the cause of what appears to be poor
performance when the subwoofer is isolated on the test bench or when compared to other units in inventory. All settings are
reset to factory default when the Restore procedure is performed.
1.
Rotate the DSP Navigation / Edit Wheel to select Restore.
2.
Press the DSP Navigation / Edit Wheel and the "Restore factory defaults?" prompt
appears.
3.
Select "No" to return to the Settings sub-menu without changing any of the
subwoofer settings.
4.
Select "Yes" to restore factory default settings and return to the Main Menu.
27
Advertisement
Table of Contents
