Settings - EAW Radius RSX series Owner's Manual

!
Initiating Output Check automatically or manually will cause the subwoofer to emit pink noise. To ensure against potentially
dangerous exposure to high sound pressure levels, it is recommended that all persons exposed to equipment capable of
producing high sound pressure levels use hearing protectors while the equipment is in operation.
Auto:
Using the Auto mode, a 2-second burst of pink noise is emitted from the low-frequency transducer. To initiate the Auto
Output Check sequence, follow these steps.
5. Rotate the DSP Navigation / Edit Wheel to select Auto.
6. Press the DSP Navigation / Edit Wheel to initiate the automatic test procedure.
Note: Status changes from "Start" to "Stop". Press it again to terminate the test sequence at any point.
7. A 2-second pink noise burst is emitted.
Note: When the subwoofer is emitting pink noise, its status changes to indicate "On". It changes back to "Off" after
the 2 second burst is complete.
8. Auto status changes to "Start" to signify the end of the Output Check cycle.
Sub:
Pink noise can be activated for manual testing of the subwoofer's transducer and amplifier.
4. Rotate the DSP Navigation / Edit Wheel to select Sub.
5. Press then turn the DSP Navigation / Edit Wheel to change the status to "On" and activate pink noise.
6. Press then turn the DSP Navigation / Edit Wheel to change the status to "Off" and deactivate pink noise.
Note: Pink noise will continue to be emitted until the Sub's status is manually changed to "Off" by the user or as a
result of running the Auto Output Check sequence.
Select Back to exit Output Check and return to the Main Menu.

Settings

From the Settings menu, the user can configure LCD display preferences, restore the subwoofer to
factory default settings and view network address and firmware version information.
Screen:
To accommodate aesthetically sensitive situations where the bright LCD display may be
distracting, the RSX12 provides three options for the user to optimize the LCD display
behavior and brightness. To change settings, rotate the DSP Navigation / Edit Wheel to
select Screen
Bright
This is the default setting suitable for well illuminated indoor/outdoor venues or
when operating in bright sunlight.
Menu navigation and parameter entry is performed with the LCD display at maximum brightness.
The Home Screen is also displayed at maximum brightness.
Dim
When maximum brightness settings become too distracting such as in darker theaters or evening outdoor events,
the LDC display can be dimmed.
Menu navigation and parameter entry is performed with the LCD display at reduced brightness.
The Home Screen is also displayed at reduced brightness.
Off
For the most aesthetically sensitive applications, the home screen can be turned off.
Menu navigation and parameter entry is performed with the LCD display at maximum brightness.
The Home Screen is blank in this mode.
Units:
Select meters or feet as the preferred unit of measurement.
Restore:
Factory settings can quickly and easily be restored. This is convenient for users managing rental inventories or for resetting a
mobile production system prior to deployment to the next venue or job site. It is also a good first step when troubleshooting
35