Side Fence Position Change - Ricoh D129 Service Manual

Hide thumbs Also See for D129:

Table of Contents

Side Fence Position Change

1.5 SIDE FENCE POSITION CHANGE

1. Open the right door of the LCT.

2. Push the down switch to lower the tray bottom plate until it reaches its lowest position.

3. Remove the front and rear side fences [A, B] ( x 1 each).

4. Install the side fences in the correct position (A4 LEF/ LT LEF/ B5 LEF).

5. Pull the end fence [C] for B5 size paper as shown ( x 1) if the the side fences are adjusted

for B5 size paper.

6. Close the right door.

7. Turn on the main power switch, and then go into the SP mode.

8. Input the correct paper size for the1200-sheet LCT with SP5181-017.

Table of Contents