Gamma 6900 Els Owner's Manual page 8

STRING REEL HOLDER INSTALLATION
The string reel holder is an 8 mm rod with
threads on both ends, and fl at surfaces
machined on one end. Thread the end of
the rod without the fl at surfaces into the
threaded boss on the side of the lower
column. Using the M6 open end wrench
positioned on the fl at surfaces, securely
tighten the rod to the lower column.
The string reel holder can hold up to 5
reels of string (depending on the size of
the string reel). Before placing the fi rst reel
on the rod, slide two M8 washers over the
pin and slide them to the boss on the lower
column. After the fi rst reel is placed onto
the rod, place two spacers between each
reel to provide enough space between
reels and allow them to turn freely without
rubbing against one another. (To provide
a smooth feed to the String Length Meter,
place the reels on the rod so the string
spools off the reel from the underside of
the reel).
After the last reel is installed, place the
remaining spacer(s) on the rod and attach
the threaded knob to the end of the rod.
9