Using The Scan Demo To Decode A Bar Code - Honeywell Dolphin 75E User Manual

Hide thumbs Also See for Dolphin 75E:
Table of Contents

Advertisement

About the HONWedge Profile
Wedge mode enables a default list of symbologies (i.e., UPCA, Code 39, Code 128, GS1128, Aztec, Data Matrix,
Maxicode, Pdf417 and QR code). You can enable or disable Symbologies for wedge mode using a profile named
HONWedge. Profile commands customize scan wedge mode behaviors. Customers set wedge mode configuration
commands using an exm file. To learn more about customized profiles, see
You can use the following HONWedge profile commands to modify the scan wedge:
Profile Commands
ENABLE_WEDGE
WEDGE_POWER_TIMEOUT
PREAMBLE
POSTAMBLE
ENTER_DELAY

Using the Scan Demo to Decode a Bar Code

The Scan Demo demonstrates the functionality of the integrated scan image engine in the terminal and is not intended as a
functional business solution.
1. On the All Apps list select ScanDemoW10
2. Point the Dolphin terminal at the bar code. For optimum performance, avoid reflections by scanning the bar code at a
slight angle.
3. Touch Scan on the touch screen or press and hold one of the Scan buttons. If you touch and hold Scan, a red beam
appears to assist with aiming; see
Description
Controls when bar code data is inserted into the keyboard buffer.
While in wedge mode, scanning is disabled and enabled using the
ENABLE_WEDGE profile command.
Use this command to optimize scan performance or to save power.
The WEDGE_POWER_TIMEOUT defaults to 30 msec. After 30
seconds of inactivity, the scan acquisition system enters a low power
state. Press the scan button to exit the low power state and power up
the scan acquisition system.
The timeout value is set using the WEDGE_POWER_TIMEOUT
profile command. The units are milliseconds.
Adds a prefix to the start of the bar code data.
Adds a suffix at the end of the data to bar code data.
Inserts a delay between bar codes when wedging the bar code data
into the keyboard buffer. A delay of ENTER_DELAY is inserted
whenever the Wedge encounters a carriage return, line feed, or tab
key. The units for ENTER_DELAY are milliseconds.
Some applications, such as Excel, may require additional processing
time when advancing to the next input field. Without a delay, data
may arrive faster than the application can process the data. You can
use the POSTAMBLE command to add a line feed at the end of each
bar code.
.
Aiming Beam
on page 3-6.
Information for Developers
on page 3-6.
Default
True
(enabled)
30 msec
200ms
3 - 3

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Dolphin 70e

Table of Contents