Using The Scan Demo To Decode A Bar Code - Honeywell Dolphin 70e Black User Manual

Using the Scan Demo to Decode a Bar Code

1. Touch > Demos
2. Point the Dolphin terminal at the bar code.
Note: For optimum performance, avoid reflections by scanning the bar code
at a slight angle.
3. Touch and hold Scan or press and hold the Scan button. Center the
aiming beam over the bar code; see
Note: By default, the left and right side buttons also trigger the scan/imager.
4. The bar code is decoded and the results appear on the screen.
Decode Results
Touch the dots or swipe
left or right to scroll
through the decode
results of past scans.
Automatic Scanning
Enable Automatic scanning mode to activate the imager for continuous scanning without requiring the
operator to touch Scan for each bar code presented in the field of view of the imager. To configure the
time interval between scan attempts, see Auto Scan Delay under
Application (page 4-4).
1. Slide the Automatic blue button to the ON position to enable the feature.
2. Touch Scan or press the Scan button to activate the imaging engine. Once activated, the imager
automatically scans and decodes bar codes presented in the field of view.
3. Touch Scan or press the Scan button to deactivate the imager.
4. Slide the Automatic blue button to the OFF position to disable the feature.
> ScanDemo to open the Scan Demo application.
Aiming Beam on page 4-6.
Scan Statistics
See
Demo Application
Configuring the Scan Demo
Configuring the Scan
on page 4-4.
4 - 3