Configuring The Scan Demo Application - Honeywell Dolphin 75E User Manual

4. Press the Back button
5. Press and hold the Scan button to activate the imaging engine. The imager scans and decodes bar codes pre-
sented in the terminal's field of view as long as the button is pressed. You can also press and hold either the left or
right side buttons to activate the imaging engine.
6. Release the Scan button to deactivate the imager.
To disable the feature set the Scan mode back to Normal.

Configuring the Scan Demo Application

1. Open the ScanDemoW10
2. Swipe left or touch Settings.
3. Select Scan, Symbology, or Profiles.
4. Modify the settings to meet your application needs, and then press the Back button
screen.
Scan Settings
Setting
Vibrate
Sound
Scan Mode
Automatic Interval
Symbology Settings
The Symbology Settings defines the bar code symbology types the scanner will decode when using the
ScanDemoW10 app. Touch the toggle box next to a symbology to enable
scanning. Swipe up or down to scroll through the list of available symbologies.
Profiles
The built-in Point of Service (POS) profiles are applied by the Scan Demo app using the Microsoft POS application
program interface (API) ClaimedBarcodeScanner.SetActiveProfileAsync, which sets the active profile on the terminal
bar code scanner. The profile strings defined by the HoneywellDecoderSetttingsV2.exm file are returned to the app
using BarcodeScanner.GetSupportedProfiles, which gets the list of profiles supported by the bar code scanner.
Profile
HON:Reset
HON:EnablePreviewOnDecode
HON:EnablePreviewOnDecodeAttempt
HON:DisablePreview
HON:EnableOOBE
to return to the Scan screen.
.
Description
When On , the terminal vibrates to indicate a good read.
When On , the terminal beeps to indicate a good read.
Three scan mode options are available:
• Normal (see Using the Scan Demo to Decode a Bar Code
• Automatic (see Automatic Scanning
• Continuous (see Continuous
Sets the number of seconds between scan attempts. An slider adjustment
allows you to choose between 0 and 30 seconds.
Description
Resets all symbology settings to disabled.
Profile not supported in ScanDemoW10 app.
Profile not supported in ScanDemoW10 app.
The default profile. Disables sending images to the application. Only
decode results are shown on the screen.
Enables the symbology types required when the built-in out-of-box
plug-in runs at first boot for scanning EZConfig labels.
on page 3-4)
Scanning)
or disable
to return to the Scan Demo
Default Value
Off
On
Normal
on page 3-3)
5 seconds
the symbology for
3 - 5