Gearchange Cable Replacement - Lotus Evora Service Notes

Lotus Service Notes
Bellcrank lever
Pivot stud
Fixing to floor channel

Gearchange Cable Replacement

For access to the gear cables, the gear lever shroud and parking brake lever trim panel must be removed,
and the gear lever/parking brake support channel released from the chassis tub floor:
- Remove centre console: See sub-section VE.5.
- Remove the engine bay undertray.
- Release cables, front: Disconnect the front end of each cable by prising off the end socket from its gear
lever or crossgate lever ball pin. Release the outer cable abutment clamp from the mounting frame. also
release the parking brake cable from the lever and disconnect the parking brake tell tale switch.
- Mounting frame: Release the gear lever mounting frame from the support channel, and withdraw.
- Release the support channel: Remove the 12 screws securing the support channel to the floor of the
chassis tub to allow the gear cables to be released from the 'P' clips inside the support channel.
- Release cables, rear: Release the cables from the transmission levers and abutment bracket by removing
the 'R' clips and 'C' clips respectively. Release all cable retaining clips and ties, and remove the cables
from the car.
Refit the cables in reverse order to removal, and check adjustment as detailed above.
Page 5
Hairpin spring
Grease these areas
Section FL