Lotus Evora Service Notes page 246

Table of Contents

Advertisement

Lotus Service Notes
Briefly pressing the button a second time will switch off Sport Mode as soon as the throttle pedal is fully
released.
Note that Sport Mode will default to 'off' at the next ignition cycle.
Cruise Control
The cruise control system is operated by
four switches mounted on the steering wheel
spokes.
-
On/off/cancel (lower left).
-
Resume (upper left).
-
Set/raise speed setting (upper right).
-
Reduce speed setting (lower right).
The three operational states of cruise
control are:
-
Off.
-
Enabled (but inactive).
-
Active.
To enable cruise control: The system will always default to 'off' whenever the ignition is turned off. To enable
cruise control, turn on the ignition, and press the on/off switch; the tell tale in the instrument panel will light to
confirm that the system is enabled (although no speed has yet been set). Alternatively, this operation may be
combined with that for activation, by pressing the on button followed by the set button (see below).
To activate cruise control: Drive the car to the desired cruising speed and press the set button. The accelerator
may now be released, but the set speed will be maintained (road gradient and winds permitting). The accelera-
tor may be used to increase speed temporarily without affecting the setting.
Note; The system cannot be activated below 20 mph (32 km/h) or above 125 mph (200 km/h).
Deactivation: Cruise control will be deactivated when any of the following actions occur:
-
The brake pedal is depressed;
-
The clutch pedal is depressed.
-
The on/off/cancel button is pressed.
In any of these cases, normal manual speed control will be restored, but the system will remain ena-
bled.
Resume: To resume cruise, press the resume switch. The vehicle speed will automatically adjust to the cruise
setting.
Changing the cruise setting: Whilst cruise is active, the speed setting can be adjusted by holding down the '+'
or '-' buttons to accelerate or slow the car to the desired new speed. On release of the button, that speed will
then be set. Alternatively, a single short press of either button will increase or decrease the setting by 1 mph
(1.5 km/h).
If the system is not active, the car can be driven to the desired speed, and the set button pressed.
To disable cruise control: To switch off the system, with cruise inactive, press the on/off switch; the tell tale
lamp will be extinguished.
Page 22
Resume
On/off/
cancel
CRUISE
CONTROLS
Section MR
Set/raise
speed
Icon
only
Reduce
speed
ohe12

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents