Lotus Evora Service Notes page 161

Lotus Service Notes
3. Remove the circlip from the outboard face of the bearing housing, and press or pull the housing from the
bearing.
4. Prise or pull the bearing dust shield off the shaft.
5. Remove the circlip retaining the bearing and press or pull the bearing from the shaft.
6. Press a new bearing into the housing,
and retain with a new circlip. Then use
special press tool T000T1438F to press
the inner race of the bearing up to the
shoulder on the shaft, and retain with a
new circlip.
7. Use special press tool T000T1439F to
press the bearing dust shield onto the
shaft and position as shown in the illus-
tration.
8. Press the inboard dust shield onto the
end of the shaft to the dimension shown
in the illustration.
9. Refit the driveshaft to the car (see
above).
Section FL
86.5 ± 0.5mm
f125
f126
f127
Page 9