Lotus Service Notes
Section EMR
Vehicle Speed Sensor
P0500
Vehicle Speed Sensor "A"
Description
This input to the ECU is from the ABS module via CAN.
Monitor:
• Continuous
Enable Criteria:
• Following conditions must occur for 5 seconds
• Engine speed > 1800rpm and < 5010rpm
• Baro > 756 mbar
• Engine in a mode that indicates that the vehicle must be moving.
Malfunction Criteria:
• KMH < 5 kmh
Potential failure modes:
• ABS module failure
• CAN bus communication error to ABS controller
Diagnostic Mask:
• The MIL will be illuminated if a fault is present for two consecutive trips.
Page 50
2009/02