Table of Contents
Advertisement
Installing in an EIA cabinet
Attention: Refer to "Safety notices and labels" on page xiii before starting any
installation procedure.
Attention: Refer to "Rack safety" on page xix for danger and caution notices
related to rack and cabinet installations.
Time required
Allow 15 to 30 minutes to complete this procedure.
Items required
You need the following items to install the switch using the slim rail rack mount
kit:
v Clamps or other means of temporarily supporting the switch in the cabinet
v Phillips #2 screwdriver
v 1/4 in. straight slot screwdriver
v 1U of rack space
v Slim rail rack mount kit
Attention: Use the exact screws specified in the procedure for use with the switch
chassis. Using screws longer than 3/16 in. can damage the switch. The different
types of screws are listed in Table 3. Make sure that you tighten all screws used in
this procedure.
Parts list
Ensure that the items listed in Table 3 and illustrated in Figure 3 on page 10 are
included in the kit.
Table 3. Parts list for slim rail rack mount kit
Item
Description
1
Bracket, front right
2
Bracket, front left
3
Bracket, rear left
4
Bracket, rear right
5
Screw, 8-32 x 5/16 in., panhead Phillips (torque to 15 in-lb, 17
cm-kg)
6
Screw, 6-32 x 1/4 in., flathead Phillips (torque to 9 in-lb, 10 cm-kg) 8
7
Screw, 10-32 x 5/8 in., panhead Phillips (torque to 25 in-lb, 29
cm-kg)
8
Retainer nut, 10-32, (for round-hole rack rails)
9
Retainer nut, 10-32, (for square-hole rack rails)
Chapter 2. Installing and configuring the switch
Quantity
1
1
1
1
10
8
8
8
9
Hide quick links:
Advertisement
Table of Contents
