Removing The Battery - IBM SAN48B-5 Installation, Service And User Manual

DANGER
1. Ensure that the new power supply and fan assembly has the same part number
2. Plug the power cord in to the power supply and fan assembly and power on
3. Verify that the LED on the new power supply and fan assembly displays a
4. Optionally, if using the Command Line Interface (CLI), enter the psShow

Removing the battery

CAUTION:
The battery contains lithium. To avoid possible explosion, do not burn or charge
the battery. Do not:
v Throw or immerse into water
v Heat to more than 100°C (212°F)
v Repair or disassemble
Exchange only with the IBM-approved part. Recycle or discard the battery as
instructed by local regulations. In the United States, IBM has a process for the
collection of this battery. For information, call 1-800-426-4333. Have the IBM part
number for the battery unit available when you call. (C003)
Local regulations may require removing the battery prior to disposing of or
recycling this product. Complete these steps to remove the battery.
1. Disconnect all power and communication cables.
2. Remove all transceivers.
3. Unscrew captive screws and remove the power supplies and fan assemblies.
4. Unscrew the fasteners and remove the sheetmetal cover.
5. On the circuit board, go to the B1 location ( 1 in Figure 16 on page 36) and
The power supply switch must be in the off position when inserting it in the
chassis. Damage to the switch could result if a live power supply is installed.
and airflow label as the power supply and fan assembly being replaced, then
install the new power supply and fan assembly in the chassis:
a. Orient the new power supply and fan assembly with the captive screw on
the right, as shown in the figure.
CAUTION:
Do not force the installation. If the FRU does not slide in easily, ensure
that it is correctly oriented before continuing.
b. Gently push the power supply and fan assembly into the chassis until it is
firmly seated.
c. Using the Phillips screwdriver, secure the power supply and fan assembly
to the chassis by tightening in the captive screw 3 .
the unit by pressing the AC power switch to the | symbol.
steady green light while the switch is operating. If the LED is not a steady
green, ensure that the power supply is securely installed and seated properly.
command at the command line prompt to display the status. Power supply and
fan assembly status can also be viewed using the Web Tools application.
remove the BR1225 battery from the holder.
Chapter 4. FRU replacement
35