Installation First remove the wallplate from the back of the unit From the top left hand corner of the wallplate, there must be clearances of at least 140mm to the right, 15mm to the left, 30mm above and 100mm below in order to mount the plug-in module.
Page 5
fi res the boiler at regular intervals to maintain a set temperature, achieving a constant ambient environment for the user. For a full explanation of all advanced features please visit our website www.danfoss-randall.co.uk or call 01234 364621 to obtain a copy of our Advanced Features Guide. Setting Optimum Start Control...
Page 6
Receiver Wiring (RF models only) RX1 & RX2 NB. For mains voltage operated systems link terminal 2 to mains live supply Commissioning (RF versions only) To tune the RX receiver to the frequency of the thermostat RESET signal, follow steps 1-5 below 1.
User Instructions Your programmable room thermostat The TP7000 allows you to programme up to 6 different time and temperature settings for each day of the week, providing complete fl exibility. It provides several energy saving features and features several useful user overrides, including a 99 day holiday mode.
Display preferences Temperature display (°C or °F) Press and hold DAY & COPY (for 2-3 seconds) until display changes. Clock display (12 or 24 hr) Press and hold NEXT & DAY (for 2-3 seconds) until display changes (AM or PM will appear in 12 hr mode) Setting the Clock &...
The unit is now in RUN mode (colon fl ashes in display) and the heating will operate according to the preset programmes. Before you change the preset programmes Your installer will have set your unit to operate in either 7-day mode or 5/2 day mode.
Page 10
c) When all 6 events are correct, press DAY to programme events for Day 2. (If you wish to repeat the previous day’s programme, simply press COPY) d) Repeat steps b & c above to programme (or COPY) events for Days 3, 4, 5, 6 & 7 Returning to RUN Mode –...
To convert to Thermostat mode The TP7000 can be converted to control at a constant user selected temperature, instead of following the set programme. Press & hold L and M together until display changes to colon blinking & default temperature (8°C). Press L or M to alter temperature as required.
J To alter main LCD display to show either time or actual room temperature – press NEXT & COPY together. Changing Batteries (not TP7000M) Batteries will last in excess of two years. Low battery indicator will fl ash on the LCD display. The user has 15 days in which to replace the batteries with high quality alkaline cells.