Product Hardware Features; Tpl-410Ap - TRENDnet TPL-410AP User Manual

TRENDnet User's Guide
Wireless
Quick Setup
Get up and running in minutes with the intuitive guided setup
N300 Wireless
Proven 300 Mbps Wireless N
Wireless Coverage
Expanded wireless coverage with MIMO antenna technology
Pre‐Encrypted
For your convenience the wireless is pre‐encrypted with a unique
password
Push Button Connection
Connect wireless devices at the touch of the Wi‐Fi Protected Setup (WPS)
button
Compatibility
Compatible with legacy 2.4 GHz Wireless devices
* Maximum wireless signal rates are referenced from IEEE 802.11 theoretical
specifications. Actual data throughput and coverage will vary depending on interference,
network traffic, building materials and other conditions
** 500 Mbps is the maximum physical Powerline data rate. Data throughput may vary by
circuit wire condition overheads. Maximum of 8 adapters (nodes) recommended for
streaming video across your network.
*** Powerline networking is limited to the same electrical system. Power strips, GFCI
outlets, and AFCI circuit breakers may degrade Powerline signals.
© Copyright 2016 TRENDnet. All Rights Reserved.
Product Hardware Features
TPL‐410AP
Hardware
Button Action
Sync Sync
Push then release
Reset
Push/Hold for 10
Reset
seconds,
then release
WPS
WPS
Push/Hold for 3
seconds, then release
TPL‐410AP / TPL‐410APK
Function
Initiate Sync/Connection and generate random network
name/key (PL LED will start blinking).
Note: The secondary or additional Powerline adapter's
Sync button must also be pushed within 2 minutes (120
sec) of pushing the Sync button on the first adapter in
order to establish connectivity.
Reset device to factory defaults (WLAN LED will go red).
Note: Will reset to the factory default private network
name "HomePlug AV".
Activates WPS (Wi‐Fi Protected Setup). The WPS LED will
blink to indicate WPS has been successfully activated.
2