Making A Special Tool For Csic Board; How To Unlock The Carriage - Epson Stylus Photo RX585 Service Manual

EPSON Stylus Photo RX585/RX595/RX610

4.1.4 Making a Special Tool for CSIC Board

The CSIC board (refer to p.73) can be easily removed by using a special tool. The
method for making the tool is described below.
1. Prepare a handle part of a clip, or a similar metal wire piece.
Clip
Figure 4-1. Making Special Tool for CSIC Board (1)
2. Bend the metal wire as shown below.
25mm
50mm
Figure 4-2. Making Special Tool for CSIC Board (2)
Disassembly and Assembly
Handle part
7mm
Special Tool

4.1.5 How to Unlock the Carriage

Some of the disassembling operations require unlocking the carriage. In those
cases, carry out any of the following operations to unlock the carriage and move
the carriage to other than its home position.
Be extremely careful not to damage the EJ Roller gear. Extra care
C A U T I O N
must be taken to avoid injury from sharp metal edges.
Turn the power off forcibly by disconnecting the power cable when the CR
Unit becomes unlocked and moves away from the home position.
Until the carriage is unlocked, turn the EJ Roller gear on the left side of the
printer in the direction of the arrow as shown in Figure 4-9.
EJ Roller Gear
Figure 4-3. How to Unlock the Carriage
Overview
Revision B
Carriage Lock Lever
61