Epson Stylus Photo RX585 Service Manual page 90

EPSON Stylus Photo RX585/RX595/RX610
Lubrication is necessary. Refer to the following section and
lubricate the specified points:
LUBRICATION OF CARRIAGE ASSY AND CR GUIDE
SHAFT (p.119)
LUBRICATION AT INSTALLATION OF CARRIAGE
ASSY (p.119)
Install the Timing Belt on the carriage with care not to confuse
the toothed areas of the inside and outside of the belt.
Up
Both inside and
outside toothed
Install the PG Left Cam by mating the D cut surfaces and with
the cam positioned outside so that it does not come in contact
with sensing area of the APG Sensor
With the cam
positioned outside
Install the Carriage Assy so that the guide is engaged with the frame.
~Rear~
Carriage guide
When installing the Cable Holder Frame, ensure that it is
positioned correctly in the front and back direction.
Disassembly and Assembly
Toothed
(inside)
No tooth
(outside)
.
Must not touch
the sensing area
APG Sensor
PG Left Cam
(Fig. 4-71)
Disassembly and Assembly of Major Parts of Printer
When installing the Carriage Assy, refer to the following sections
A D J U S T M E N T
R E Q U I R E D
and perform the necessary adjustments:
5.2.6 PG Adjustment (p.105)
5.2 Adjustment by Using Adjustment Program (p.101)
PW Sensor
Timing Belt
CR Encoder
Figure 4-75. Carriage Assy (rear)
C H E C K To remove the Cartridge Cover, it is necessary to remove the
P O I N T
Cartridge Cover Hinge. However, there is no special means of
releasing the hook. Therefore, insert a slotted screwdriver as
shown below and break the hook. (In installation, replace it with a
new one)
Cartridge Cover
Insert here
Revision B
Hook
Cartridge Cover Hinge
90