EPSON Stylus Photo RX585/RX595/RX610
INSTALLATION PROCEDURE FOR THE MIDDLE HOUSING ASSY
1.
Check the following before installing the Middle Housing Assy:
Stacker operates properly.
(See p.81)
The cables and FFCs are routed properly. (Fig. 4-27), (Fig. 4-28)
2.
Slide the Front Frame Ground Plate rearward and remove it from the Middle
Housing Assy.
3.
Lead all the connector cables and FFCs through the space and install the Middle
Housing on the printer. (Fig. 4-29)
~Rear right~
~Rear left~
After setting the
ferrite core in place,
stick the acetate tape.
~Left side~
Figure 4-27. Routing the Cables
(Continued to next page)
Disassembly and Assembly
Hooks
Removal of Exterior Parts
Acetate Tape 18x20 (x4)
PF Encoder FFC
Figure 4-28. Routing the Cables and FFCs
~Front left~
Lead all the cables and FFCs here
Figure 4-29. Leading Connector cables and FFCs
Revision B
Hooks
Lead the Head FFC here
71