Table of Contents
Advertisement
Effervescence Operation
·
With the whirlpool operating, rotate the outer ring of
the keypad until the effervescence icon is flashing.
·
Press OK to activate the effervescence ports. The
"
"
effervescence action will start at the flow volume last
set in the flexjet flow mode.
·
Increase or decrease the flow volume by pressing
either the up or down arrow buttons on the keypad.
NOTE:
The effervescence mode is intended to be a
relaxing, soothing experience. The Flexjet mode and
backjets will automatically turn off when the
effervescence mode is activated. Chromatherapy may
be used with all modes of operation.
·
Press OK while the effervescence mode is flashing
"
"
to turn off the effervescence ports.
·
Repeat the above steps for the second keypad.
Chromatherapy Operation
NOTE:
Chromatherapy may be used with all modes of
operation or when the pump is not operating.
When the pump is not operating, only one of the
keypads will control the chromatherapy operation.
·
Chromatherapy Cycle.
activated, the chromatherapy lights will
automatically and continuously cycle through the
eight colors; white, violet, indigo blue, aqua blue,
green, yellow, orange, and red. One cycle through
all eight colors takes approximately one minute.
Rotate the outer ring to select this mode and press
"
OK to activate it. Press OK while the
"
chromatherapy mode is active to end the cycle.
·
Chromatherapy Specific Color Selection.
this mode is activated, you may choose a specific
color for the bath. Rotate the outer ring to select this
mode and press OK to activate it. Use the
"
up/down arrows to reach the desired color. Press
"
OK while the chromatherapy mode is active to end
"
the Chromatherapy operation.
REMOTE CONTROL OPERATION
REMOTE CONTROL OPERATION
NOTE: Refer to your Homeowners Guide for detailed
instructions on your remote control.
·
Because your unit has two keypads and two remote
controls, you must program both remote controls.
For detailed instructions, refer to the supplemental
instruction sheet, Programming Your Remote
"
Controls , packed with your literature.
"
·
The remote control places the whirlpool functions at
your fingertips. You may access and modify all
modes/features from the remote control. The
waterproof remote control is designed to be used in
the bath and will float in the water. The remote
control uses two AAA batteries.
·
The mode selector button functions in the same way
as the outer ring. When M is pressed, one of the
modes will flash on the user keypad. If M is
pressed again, the next mode in clockwise order will
flash. When the desired mode is flashing, press
"
OK to activate it.
"
1141609-T01-A
When this mode is
"
"
"
" "
" "
·
·
OK
·
·
·
·
8
·
When
OK
·
·
·
M
M
14
OK
8
OK
OK
OK
2
OK
1
AAA
Advertisement
Table of Contents
