Table of Contents
Advertisement
CLEAN-UP AFTER INSTALLATION
CLEAN-UP AFTER INSTALLATION
·
When cleaning up after installation, do not use
abrasive cleansers, as they may scratch and dull the
whirlpool surface. If necessary, use warm water and
a liquid detergent to clean the surface of the
whirlpool, user keypad and remote control.
·
Remove stubborn stains, paint, or tar with turpentine
or paint thinner.
Do not allow cleaners containing
petroleum distillates to remain in contact with
any whirlpool surfaces for long periods of time.
Remove plaster by carefully scraping with a wood
edge. Do not use metal scrapers, wire brushes, or
other metal tools. Use a powder-type detergent on a
damp cloth to provide mild abrasive action to any
residual plaster.
INSTALL THE REMOVABLE PILLOWS
INSTALL THE REMOVABLE PILLOWS
CAUTION: Risk of product damage.
submerge the pillows underwater or use them as
seat cushions.
NOTE:
For best attachment to the whirlpool surface,
moisten the back surface of the pillows at the suction
cup locations.
·
Clean the whirlpool surface of any soap film or oils.
Moisten the suction cups located on the back side of
the pillows. Position the small pillows above the
backjets and above the waterline by pressing down
firmly with the heel of your hand. Check to make
sure that the pillows are attached firmly to the
whirlpool.
·
Detach the pillows by lifting them off the whirlpool
surface.
1141609-T01-A
·
·
Do not
·
·
11
Position the small pillows as
desired above the waterline
and above the backjets.
Advertisement
Table of Contents
