Table of Contents
Advertisement
·
Turn on the chromatherapy cycle and allow it to
sequence through all eight colors; white, violet,
indigo blue, aqua blue, green, yellow, orange and
red. It takes approximately 1 minute to cycle through
all eight colors.
·
Verify functions using the remote controls. Refer to
the Remote Control Operation section of this guide
"
and supplemental instruction sheet, Programming
Your Remote Controls , packed with your literature.
NOTE:
For additional information on whirlpool
operation, see the Confirm Proper Operation section
"
of this guide.
COMPLETE THE FINISHED WALL/DECK
COMPLETE THE FINISHED WALL/DECK
·
If you have not already done so, carefully remove
the protective tape from the whirlpool rim.
·
Cover the framing with water-resistant wall material.
Seal the joints between the whirlpool rim edge and
the water-resistant wall material with silicone sealant.
·
Tape and mud the water-resistant wall material.
Install the finished wall to the water-resistant wall
material so it is 2mm above the bath surface. Seal
the joints between the whirlpool rim and the finished
wall material with silicone sealant.
·
Install the faucet trim according to the instructions
packed with the trim.
1141609-T01-A
"
"
"
"
Whirlpool
Whirlpool
·
·
·
·
/
·
/
/
2mm
·
Apply silicone sealant to the water-resistant
wall material and the finished wall.
Install the finished
wall material.
First install water-resistant
wall material.
Drop-In Installation
Apply silicone sealant to the water-resistant
wall material and the finished wall.
Install the finished wall
material.
First install water-resistant
wall material.
Flush Installation
10
8
/
/
/
8
1
Advertisement
Table of Contents
