Table of Contents
Advertisement
· Rotate the outer ring until the heater button is
flashing. Press OK to turn the heater off. Press
"
"
"
OK again to turn the heater back on. The heater
"
will help to maintain the water temperature up to
o
o
104 F (40 C).
·
Press the Power On/Off button a second time to turn
the whirlpool off. The lights near the whirlpool floor
will remain illuminated until the keypad enters the
sleep mode.
·
Repeat the steps above to verify the operation of the
second keypad.
NOTE:
A built-in timer automatically stops the pump
and motor after approximately 20 minutes of operation.
Activates Mode
Selected
Backjet Mode-
Adjust Pulse
Rotate outer ring to
access desired mode.
Chromatherapy-
Specific Color
Power On/Off
Lighted User Keypad
MODES OF OPERATION
MODES OF OPERATION
Backjet Operation
·
Rotate the outer ring until the backjet mode is
flashing and press OK . The backjet pulsing action
"
will start at medium speed. The backjet pulsing
action will start at medium speed. The backjets
pulse from the bottom of the whirlpool toward the
top, with water flow and pulse action occuring
from two backjets at a time.
NOTE:
If the water level falls below the water level
sensors, the backjets will stop. The backjet icon and
indicator bar on the user keypad will flash. The backjets
will automatically restart when the water level covers
the sensors.
· To increase or decrease the backjet pulsing action,
press either the up or down arrow buttons on the
keypad, while the backjet mode is active.
·
To increase or decrease the flow volume to the
backjets, rotate the outer ring to the Flexjet mode,
press OK to activate the mode, and press either
"
"
the up or down arrows on the keypad. This also
increases or decreases the flow to all modes.
NOTE:
To activate or deactivate different modes while
the backjets are operating, rotate the outer ring until the
disired mode is flashing and press OK . (Example: To
turn the heater off, rotate the ring until the heater icon is
flashing and press OK ).
"
·
Press OK while the backjet mode is flashing to
"
"
turn off the backjets.
·
Repeat the above steps for the second keypad.
1141609-T01-A
Flexjet Flow Mode
Heater On/Off
"
"
"
"
·
OK
·
·
Increases Flow
or Pulse Rate
Effervescence Mode
Indicator Bar - Shows
water flow volume or
pulse rate
Chromatherapy Cycle
Decreases Flow
·
·
·
(
·
·
13
/
Turn the Flexjet
trim clockwise to
decrease the flow.
OK
OK
)
OK
40
20
Turn the Flexjet trim
counterclockwise
to increase the flow.
OK
OK
OK
Advertisement
Table of Contents
