Motorola AP6562 Installation Manual page 32

32
• Enable NAT on the WAN Interface - Select the checkbox to allow traffic to pass between the access
point's WAN and LAN interfaces.
17. Select Next. The Initial AP Setup Wizard displays the Radio Configuration screen to define support for
the 2.4GHz radio band, 5GHz radio band or to set the radio's functionality as a dedicated sensor.
NOTE
18. Set the following parameters for the radio:
• Configure as a Data Radio - Select this option to dedicate this radio for WLAN client support in either
the selected 2.4 or 5GHz radio band.
• Radio Frequency Band - Select either the 2.4GHz or 5.0GHz radio band to use with the radio when
selected as a Data Radio. The selected band is used for WLAN client support. Considers selecting
one radio for 2.4GHz and another for 5GHz support when supporting clients in both the 802.11bg
and 802.11n bands.
• Power Level - Use the spinner control to select a 1 - 23 dBm minimum power level to assign to this
radio in selected 2.4 or 5.0 GHz band. 1 dBm is the default setting.
The ADSP Sensor Server field displays at the bottom of the screen only
if a radio has been dedicated as a sensor.
AP6562 Access Point