Description Of Lcd Annunciators - Oakton pH 5+ Instruction Manual

Instruction Manual
CALIBRATE: Press to begin calibration of the selected mode.
Press again during calibration to abort calibration and return to
measurement mode without confirming any values.
During setup mode, function is similar to "escape" or "go
back", returning to the previous screen.
With meter off, press and hold
() while powering on.
Increase value or scroll up in Setup or Cal modes.
Decrease value or scroll down in Setup or Cal modes.
HOLD: Freezes measured reading—indicated by "HO". Press
again to resume live reading.
ENTER: Confirms values in calibration mode. Confirms
selections in setup mode.

Description of LCD Annunciators

The custom LCD consists of 3½-digit segments which uses annunciators for pH, mV or
o
C (Temperature). No annunciator is shown in Ion mode. Other annunciators include
"HO" (when HOLD function is activated) and "LO" (low battery condition).
to select the reset menu
3
pH 5+, pH 6+, Ion 6+